The connections between notes sometimes get confused. The side of the note that they emerge from is not consistent, sometimes they run through notes instead of around them, sometimes they have sharp angles and enter on a far side of destination note. I don't see any way to adjust either the connection points on the notes or the paths taken by the lines.

I just had a whole fretboard go crazy where every line went out at a strange angle, took a sharp bend, and entered the target note from the back. This happened after first aligning and then distributing the five fretboards on a page. I wish I'd taken a screenshot, but I was desperate to get the diagram back to how it was supposed to look. But I can show you this snippet, which shows connections going straight across other notes. It's a little hard to see but there are dotted lines connecting the pairs of square notes across the round notes on the bottom. The lines used to dodge nicely out of the way.

nd1.jpg

Is there anything we can do to correct this type of situation? Am I missing some inspector or other property that can adjust how connections are routed? Thanks if you can clarify. Once a fretboard gets this way, deleting notes and connections doesn't seem to change anything. It's as if the model is confused about the placement order.

Best wishes and say healthy.

Trevor